With the unit off, open the printer cartridge storage area. Thank you Bert – that was totally helpful. Solution and Diagnostic Data Collection. If it is dirty the ‘white’ stripe will not be found and therefore the scan bar trys to move more to the right, while it is bumping against mechanical barriers. All the stuff out there is being made in China, so bets are on that they won’t hold up at all! Hold down cancel while turning printer on I followed the instructions to clean the scanner glass, using the instructions form:

Uploader: Dogal
Date Added: 10 May 2016
File Size: 34.26 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 46984
Price: Free* [*Free Regsitration Required]

Good luck, cdp – Anonymous. I removed psc 2410 printer rear paper jam door and found two screws–so I removed them and pulled down on the trim piece–removing it–and low and behold I found that the ribbin cable top one on psc 2410 printer was loose–I unpluged both ribbins and reseated themsure enough it started working scanner light comes on now at initilization working fine now and it was free!!!.

No software or drivers are available for this product psc 2410 printer the selected operating system. Went through the full open and clean instructions a while ago and it fixed it, but now it is psc 2410 printer again. Support Questions Ask a Question 5 Answers 12 Score once turned on, my photosmarts starts clicking and won’t operate!

These are some common tools used to work on this device. I orinter remember exactly how to remove the cover or how many screws you have to remove, but it should be intuitively obvious if you are somewhat mechanically inclined. I finally got it to work, clicked on the link below: It would be attached to the board you’re looking for. After you manually move the scanner bar, you should be able to turn the psc 2410 printer on and go through the initialization with the printer in it’s partly disassembled condition.


This worked for me. Replaced the black cartridge for another brand new one. Or, view all available drivers for your product below.

We have switched the power on and off several times, and it still printeg In reply to bjbrown97’s post on July 6, Attached to that, on the back side is the psc 2410 printer Card”.

HP psc 2410 all-in-one printer won’t scan

I am getting an error message. This product detection tool installs software on your Microsoft Windows device that allows HP to detect and gather data about your HP and Compaq products to provide quick access to support information psc 2410 printer solutions.

I tried everything that was listed on this forum. You will also have to snap off the bezel where the buttons are located, since psc 2410 printer is a screw underneath it.

HP PSC 2410 Photosmart All-in-One Printer User Guides

I kept pressing these two keys for more than two minutes. This product cannot be identified by Serial Number alone.

THEN, the issue with the blinking on light and stuck in start-up – I then found in my pulling pirnter the top cover, I had unplugged on of the psc 2410 printer plugs that lead to the scanner my scanner’s light was not even on. First of all, I will tell you that you psc 2410 printer need a Torx screwdriver.


HP PSC Photosmart All In One Repair – iFixit

The same repetitive “kicking” sound, with printer “on” button flashing on and off; the only way to stop it was to disconnect the power cord. I also cleaned contacts on both cartridge and carriage side with swab and alcohol. None of them worked, I got the message on screen acknowledging semi-full reset, as well as full reset, 240 the unit is still flashing “insert black psc 2410 printer photo cartridge”.

Psc 2410 printer to believe that HP didn’t take the time to attempt to alert it’s customers, now past tense. Turn the unit on leaving the lid open, gently pulling the ink cartridge unit to the middle. Pzc hp on line did nothing, they just want to sell you the up grade printer.

HP PSC all-in-one stuck in start up | FixYourOwnPrinter

I could do nothing with the printer, not even scan. Eric Ber Replied on July 7, I just got a this printer psc 2410 printer a friend, and older printer. If it’s the scanner bar “clicking” thats the problem then see ; http: Try power on while holding the cancel button.